Installation
Mirror driver only get downloaded, NOT installed. This need to be done manual.
For first time install you best don't register it as service, this can always be done later from the
winvnc systray. First test if it works, and then register as service when needed.
Automate Installation
If you need to install UltraVNC on a large number of computers, you might consider automating the installation.
The following command line parameters can be passed to the setup:/dir="Dirname"Sets installation directory to Dirname./no restartSuppresses a reboot at the end of the installation.
Not required since the installation no longer requires are boot./silent or /very silentSuppresses either pop-up of dialog boxes or any GUI at all./loadinf="Filename"Loads the configuration file Filenamefor the installation.
This configuration file can be generated by going through setup with UltraVNC-xxxx-Setup.exe /saveinf="Filename".Filename should be fully qualified./logWrites a log file to the Temp directory.
Could be used for debugging.